3.5 KiB
MiniMax RC Yacht
Parametric FreeCAD reconstruction of a small MiniMax-style radio-controlled yacht.
This is an independent reconstruction based on the published MiniMax dimensions. It is not the official MiniMax STL or a claim of dimensional identity with the licensed design.
Current model
- Hull length: 220 mm
- Maximum beam: 76 mm
- Hollow shell wall: 1.6 mm
- Design waterline: 19 mm
- Servos: 2 × SG90 envelope models
- Controller envelope: WEMOS LOLIN ESP32-S2 Mini v1.0.0
- Controller board envelope: 34.3 × 25.4 mm
- Estimated target mass: 195 g
- Preliminary stability estimate: positive
- Rudder pushrod route: side route around the ESP32 tray
All SG90 and ESP32 fit dimensions are design estimates unless explicitly marked as measured. Verify the physical parts before printing final mounts.
Files
MiniMaxHull.FCStd— parametric FreeCAD documentstl/— printable-part exports, including the removable cockpit hatchscripts/MiniMaxSimulation.FCMacro— FreeCAD simulation macroparameters/design_parameters.json— design inputs and uncertainty markersreports/virtual_simulation_report.json— latest virtual verification result
Run the simulation
- Open
MiniMaxHull.FCStdin FreeCAD. - Open
View -> Panels -> Python consoleor useMacro -> Macros. - Run
scripts/MiniMaxSimulation.FCMacro. - The macro prints the report and writes
reports/virtual_simulation_report.jsonnext to the document.
The macro performs a qualification suite: geometry validity, outer-hull waterline displacement sweep, center of buoyancy, rudder and sheet sweeps at 5 degree resolution, preliminary stability, mass/CG sensitivity cases, wind-load cases, production-part validity, hatch fit checks, and FreeCAD STL mesh validation.
The current virtual result is PASS_WITH_REVIEW: the design waterline gives approximately 193.69 g displacement, preliminary GM is approximately 37.33 mm, and both actuator routes pass the collision sweep. The result is not a release for water testing: mass, servo torque, center of gravity, gasket compression, cable routing, and printed-part sealing still require physical verification.
The calculations are engineering approximations. They are not CFD, FEM, wave dynamics, servo torque validation, or a watertightness proof.
Chrono Multibody rudder simulation
simulation/chrono_rudder_dry.cpp— Chrono Multibody servo, pushrod, rudder, mass/inertia, NSC contact material, and friction modelsimulation/CMakeLists.txt— native build configurationreports/chrono_rudder_dry_report.json— verified headless sweep resulttools/chrono_report_viewer.py— browser visualization of the verified sweepreports/freecad_yacht_chrono_viewer.html— full FreeCAD-derived yacht viewer with rudder sweepdocs/chrono_ubuntu.md— Ubuntu and Docker instructionsDockerfile.chrono— reproducible headless Chrono build
The checked-in Chrono executable is headless. The browser viewer visualizes the measured Chrono result; it is not a real-time 3D Chrono renderer. A GUI build with Irrlicht or VSG is documented as a separate follow-up because it requires optional Chrono GUI modules and display forwarding.
The STL files are preliminary exports. Before real-world testing, verify slicing, wall thickness, clearances, fastener access, sealing, actual component mass, center of gravity, and servo travel with the physical hardware.
Real-world water and electronics tests must follow successful virtual checks and a physical inspection of the printed parts.