MiniMax RC Yacht

Parametric FreeCAD reconstruction of a small MiniMax-style radio-controlled yacht.

This is an independent reconstruction based on the published MiniMax dimensions. It is not the official MiniMax STL or a claim of dimensional identity with the licensed design.

Current model

  • Hull length: 220 mm
  • Maximum beam: 76 mm
  • Hollow shell wall: 1.6 mm
  • Design waterline: 19 mm
  • Servos: 2 × SG90 envelope models
  • Controller envelope: WEMOS LOLIN ESP32-S2 Mini v1.0.0
  • Controller board envelope: 34.3 × 25.4 mm
  • Estimated target mass: 195 g
  • Preliminary stability estimate: positive
  • Rudder pushrod route: side route around the ESP32 tray

All SG90 and ESP32 fit dimensions are design estimates unless explicitly marked as measured. Verify the physical parts before printing final mounts.

Files

  • MiniMaxHull.FCStd — parametric FreeCAD document
  • stl/ — printable-part exports, including the removable cockpit hatch
  • scripts/MiniMaxSimulation.FCMacro — FreeCAD simulation macro
  • parameters/design_parameters.json — design inputs and uncertainty markers
  • reports/virtual_simulation_report.json — latest virtual verification result

Run the simulation

  1. Open MiniMaxHull.FCStd in FreeCAD.
  2. Open View -> Panels -> Python console or use Macro -> Macros.
  3. Run scripts/MiniMaxSimulation.FCMacro.
  4. The macro prints the report and writes reports/virtual_simulation_report.json next to the document.

The macro performs a qualification suite: geometry validity, outer-hull waterline displacement sweep, center of buoyancy, rudder and sheet sweeps at 5 degree resolution, preliminary stability, mass/CG sensitivity cases, wind-load cases, production-part validity, hatch fit checks, and FreeCAD STL mesh validation.

The current virtual result is PASS_WITH_REVIEW: the design waterline gives approximately 193.69 g displacement, preliminary GM is approximately 37.33 mm, and both actuator routes pass the collision sweep. The result is not a release for water testing: mass, servo torque, center of gravity, gasket compression, cable routing, and printed-part sealing still require physical verification.

The calculations are engineering approximations. They are not CFD, FEM, wave dynamics, servo torque validation, or a watertightness proof.

Print status

The STL files are preliminary exports. Before real-world testing, verify slicing, wall thickness, clearances, fastener access, sealing, actual component mass, center of gravity, and servo travel with the physical hardware.

Real-world water and electronics tests must follow successful virtual checks and a physical inspection of the printed parts.

S
Description
No description provided
Readme
1.9 MiB
Languages
HTML 40.6%
C++ 35.9%
Python 19.8%
CMake 3.7%